UEC DSD 700 Especificaciones descargar pdf (Pagina 9)

DSD 700 OPERATING INSTRUCTIONS 9

DSD, VCR, TV (using SCART or RF Interface)

NOTE: As the LNB carries a small voltage from the IRD on

its centre connector, it is recommended that the

decoder is switched off at the mains before

connecting or disconnecting the LNB connector.

1 Connect the coaxial cable from the LNB on the satellite dish to the

socket marked LNB IN on the DSD. The connector on the coaxial

cable should be turned until it is finger tight.

2 Connect the terrestrial antenna connector to the RF IN socket on

the DSD.

3 Connect the RF OUT socket on the DSD to the RF IN socket on the

VCR.

4 Connect the RF OUT socket on the VCR to the RF IN socket on the

TV.

The following instructions applies if your TV and VCR have SCART or

RCA connectors:

5 Using a SCART-to-SCART (or SCART to RCA) cable, connect the

TV SCART socket on the DSD to the SCART (or RCA) socket on

the TV.

6 Using a second SCART-to-SCART cable (not supplied), connect

VCR SCART socket on the DSD to the TV SCART socket on the

VCR.

Republic of South Africa

WARNING! High Voltage

DANGER! Do not open

Unauthorised opening

renders warranty invalid

Protect against moisture

REAR PANEL

SCART TO SCART

SCART TO RCA

RF IN

RF OUT

RF IN

VCR SCART

TV SCART

VCR

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 37 38

Sin comentarios

UEC DSD 700 Especificaciones Pagina 9